Why Does Wood Pop In The Fire

wood referensi web image

Why Does Wood Pop In The Fire. As the gas escapes, the fire will emit an audible pop or crack. Some will get stuck in the wood.

Why Does Burning Wood Pop & Crackle? Sciencing
Why Does Burning Wood Pop & Crackle? Sciencing from sciencing.com

When the wood is burned, combustible gasses will be released. And, in these moments, the popping and crackling picks up and increases until the moisture in. The holes created by the insects will give the gasses an escape route.

This Is Because The Moisture In The Wood Begins To Evaporate Quickly, While Also Pushing The Moisture Out Of The Wood In The Form Of More Steam.


When the wood is burned, combustible gasses will be released. Make your fire on a dry surface. The holes created by the insects will give the gasses an escape route.

Some Will Get Stuck In The Wood.


This same principle rings true when burning wet or moist firewood. Softwoods such as conifers and pines are more likely to spark due to their high resin content. Typically, when the moisture in the wood is high, the pops and crackling noises are a lot more frequent.

In Basic Terms, It Has Something To Do With The Combustion Gases Escaping From The Wood.


As the gas escapes, the fire will emit an audible pop or crack. When resin bits catch fire, they explode and throw hot sparks up the chimney and out the front of the fireplace. Wood is porous and easily absorbs any moisture it.

Unlike Wood, Water Doesn’t Convert Into Heat When Burned.


As the trapped moisture heats up, it will. Woods such as red cedar and poplar are resinous, containing tree saps that are highly flammable. And, in these moments, the popping and crackling picks up and increases until the moisture in.

Moisture That Might Have Escaped Without A Problem Will Now Be Trapped Inside This Freshly Formed Seal, Causing The Wood To Pop Even More Frequently Than It Would Have Otherwise.


Trapped moisture can also cause wood to pop and crackle from the creation of steam. If you place a pot of water on the stove and activate the burner, it will evaporate as steam.